[. . . ] Do not expose the battery compartment to water, as water entering the device may cause major damage. •• Active mobile phones in the vicinity may cause interference. [. . . ] Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household EN 3 English Notice waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health.   Disclaimer Philips is not responsible for any loss of valuables. 2 Your InRange device To fully benefit from the support that Philips offers, register your product at www. philips. com/welcome. Your InRange device This InRange device is compatible with the following iPhone and iPad models: • • The New iPad iPhone 4S Introduction This InRange device offers you a loss prevention solution that allows you to: • locate your iPhone 4S/New iPad from the InRange device. • attach the InRange device to your valuables and locate them from your iPhone 4S/New iPad. • alert you from the InRange device when your iPhone 4S/New iPad is beyond the set range. • alert you from your iPhone 4S/New iPad when your valuables attached to the InRange device are beyond the set range. What's in the box Check and identify the contents of your package: • InRange device • Protective pouch • Metal lock • Cell battery (CR2016) (for replacement) • Battery eject tool • Lanyard • Quick start guide • Safety sheet 4 EN For first-time use: To fully benefit from the support that Philips offers, register your product at www. philips. com/welcome. Your InRange device 1 Enable Bluetooth on your iPhone 4S/New iPad. »» The power indicator flashes red and green alternately, and the InRange device beeps. Tip •• To switch off the InRange device, press and hold for more than 3 seconds until the power indicator turns off and the InRange device beeps. To switch on it again, press and hold until the power indicator flashes red and green and the InRange device beeps. 2 To replace the battery: Download and install Philips InRange from Apple App Store. 3 2 1 + InRange 1 2 3 Use the supplied metal pin to eject the battery compartment. Push to close the battery compartment. EN 5 English 3 Prepare Prepare the InRange device Set up Bluetooth connection Note •• Before setup, make sure that you have enabled Bluetooth on your iPhone 4S/New iPad, and the power indicator on the InRange device flashes red and green alternately. 1 Put the InRange device into the protective pouch, then use the supplied metal lock to secure the pouch. 2 Attach the InRange device to your valuables (objects), such as a key or bag. 5 Tap 'Philips AEA1000' to start pairing and connection between your iPhone 4S/New iPad and the InRange device. 3 4 Run Philips InRange on your iPhone 4S/ New iPad. »» The iPhone 4S/New iPad starts to search for the available InRange device. [. . . ] Press and hold on the InRange device for more than 3 seconds to switch on the device. Check whether you have enabled Bluetooth on your iPhone 4S/New iPad. • Why is that there is no beep when my iPhone 4S/New iPad and InRange device are out of range? [. . . ]